2.0 KiB
WB8WFK ARDF Foxoring Transmitter
This is a simple, inexpensive, transmitter controller for conducting ARDF Foxoring competitions and for demonstrating ARDF principles. The software project is an Arduino script that builds for and runs on most Arduino-like products, including AdaFruit's Metro Mini 328, or SparkFun's Arduino Pro Mini 328, and many more.
After being programmed, the controller is configured via a serial port on the microprocessor. An Arduino board that includes a USB-to-Serial converter will allow you to configure the controller with a simple USB cable running between a USB port on your computer to one on the Arduino board. Less sophisticated Arduino boards lacking a USB-to-Serial converter will require a special FTDI cable like AdaFruit's FTDI Serial TTL-232 USB Cable, or SparkFun's FTDI Cable 5V.
The controller includes an output pin for controlling a transmitter for sending Morse code characters (high = key down; low = key up) and a separate pin that sends the Morse code as audio tones that can be used to drive a speaker. The controller can also provide a sequence of starting-tones prompting competitors to begin a competition, and can thus serve as an electronic starting "gun" for use in ARDF events.
Serial Commands
The controller serial interface operates at 57600 baud that can be accessed using any serial TTY interface program such as PuTTY or Arduino's own Serial Monitor tool. It provides a command prompt > indicating that it is ready to receive recognized the following commands.
CAL
FAC
DIP
LED
SYN
TEM
ID
GO
RST
SPD
STA
VER
A schematic design, a bill of materials, and a source for ordering a printed circuit board will be made available soon.