1.7 KiB

Czysty Wina Historia

ADC2 Example

(See the README.md file in the upper level 'examples' directory for more information about examples.)

In this example, we use ADC2 to measure the output of DAC.

How to use example

Hardware Required

A development board with ESP32 SoC (e.g., ESP32-DevKitC, ESP-WROVER-KIT, etc.)
A USB cable for power supply and programming

We use ADC1_CHANNEL_7 (GPIO27) and DAC_CHANNEL_1 (GPIO25) by default, you need to short the two GPIOs (if you have changed the ADC2 and DAC channel, please refer to Chapter 4.11 of the ESP32 Technical Reference Manual to get the pin number).

Configure the project

make menuconfig

Set serial port under Serial Flasher Options.
Set ADC2 and DAC channel in "Example Configuration"

Build and Flash

Build the project and flash it to the board, then run monitor tool to view serial output:

make -j4 flash monitor

(To exit the serial monitor, type Ctrl-].)

See the Getting Started Guide for full steps to configure and use ESP-IDF to build projects.

Example Output

Running this example, you will see the following log output on the serial monitor:

ADC channel 7 @ GPIO 27, DAC channel 1 @ GPIO 25.
adc2_init...
start conversion.
1: 150
2: 203
3: 250
4: 300
5: 351
6: 400
7: 441
8: 491
9: 547
10: 595
...

Troubleshooting

program upload failure
- Hardware connection is not correct: run idf.py monitor, and reboot your board to see if there are any output logs.
- The baud rate for downloading is too high: lower your baud rate in the menuconfig menu, and try again.

For any technical queries, please open an issue on GitHub. We will get back to you soon.

1.7 KiB Czysty Wina Historia