wfview/USERMANUAL/wfview-1.0.txt

173 wiersze
3.3 KiB
Plaintext

View:
buttons
spectrum scope/waterfall:
spectrum mode
depending on the rig you can select:
center
fixed
scroll-center
scroll-fixed
spectrum span
the spectrum span is active in center modes and you can select
here the span you like, just as on the rig.
spectrum edge
here you can select the edge number as programmed in the rig.
Most rigs will accept four edges.
tofixed
clear peaks
here you can clear the peaks. Currently we only support persistent
peaks and at some point we are changing that to be able to have it
go away after 10 seconds, like the rig does.
enable/disable wf
on/off switch for the scope/waterfall
wf theme
Currently fixed selections how the scope and waterfall look like
with colors. At som epoint we may add the ability to accept the
RGB values like the rig does.
mode
here you can select the mode used for tx and rx. To enable data mode there is
a separate button to select.
Data mode
switch the D mode on/off on the selected mode.
receive (and tx) filter
Select the predefined filter settings of the rig.
Rigs also will change the TX width accordingly.
transmit/receive
this button alternates between TX and RX; Note that to
enable TX, you need to do that first on the Settings tab
enable/disable atu
if your rig supports an internal ATU, you can enable
disable it here. Note that we have not tested external
ATU's yet. It may follow, it may not...
enable/disable rit
Enable the RIT function; currently no feedback on the rx shift.
tune
Button to initiate the ATU. Note that we have not tested external
ATU's yet. It may follow, it may not...
repeater setup (expand)
TODO
preamp
You can select the preamp mode(s). Some rigs can only accept
preamp OR att.
attenuator
you can select the rig attenuator here. Some rigs can only accept
preamp OR att.
antenna selection
TODO
controls
main dial (there is no sub dial yet)
by turning the dial, or using mouse wheel or clicking on the scope
you can change the current frequency. The step size is below the
main dial and you can select most known stepsizes there.
An Flock button will effectively lock the freq to prevent accidental
mis clicking/rotating mouse actions.
rit dial
the rit dial will effectively modify the offset in RX; useful on the VHF
bands and up. Note that you need to switch on RIT for that
You can use the mouse wheel to change the offset/shift.
rf gain
This slider controls the RF gain of the rig
af gain (defaults to 100%
This controls the AF Gain locally, defaults to 100% and does not
increase/decrease the AF gain on the rig itself.
(Else, a remotely controlled rig could make a lot of noise ;-))
sq
The squelch control
tx power
Control that sets the power in % with the same accuracy as the rig
so if your rig is 50 Watt at 47%, this slider will too.
mic gain
The mic gain slider sets the modulation level on the rig.
scope reference level
The scope reference level can be set here and TODO because
need to check if this follows per band or not.
=============================
Frequency
On this tab you can insert a free frequency in kHz.
examples:
7100 --> 7.1 kHz
430. --> 430 MHz
e.g. the dot itself defines currently that you specify MHz.
It will not accept anything beyond the dot. E.g. 430.125
will end up doing nothing.
After entering, you will be switched back to the View tab.
STO/RCL: TODO
Settings