- Removed secondary decoder
- Updated image encoding at tracker firmware
- Updated image encoding at decoder software
- Implemented more sophisticated website
- Added error transmission
- Adjusted MCU speed to the highest rate
- Implemented configuration that allows GPS to be switched on permanently at a certain battery voltage
- Decreased humidity sensor accuray
- Imcreased voltage measurement accuracy
- Added temperature measurements of STM32 and Si4464 to TrackPoint struct
- Added light intensity measurements of OV5640 to TrackPoint struct
- Cleaned up (removed unused things)
- Implemented more accurate measurements for PAC1720
- Implemented failure detection for PAC1720 and ublox chips
- Fixed bug in Si4464 driver which used power when switched off
- Added more data readouts for GPS receiver (pDOP, gpsFixOK)
- Changed way of determination if GPS fix is good
- Implemented temperature measurement of STM32
- Added error detection of I2C bus
- Removed Milliseconds from ptime_t
- Fixed bug in timestamp conversion
- Removed RBAT measurement implementation (it was very inaccurate)
- Avoid radio being switched off when next packet is waiting for being transmitted
- Tidied up tracking manager
Implemented LOWBATT1 and LOWBATT2
Switch off camera at JPEG validation process
Moved JPEG validation section
Added GPS communication error message
Changed Watchdog behavior (1sec delay inserted)
Tidy up
Modified APRS format of Image and Log packets
Implemented image
Added memory address to log command (Serial USB console)
Added failsafe to ADC measurements (if PAC1720 fails)
Improved radio buffer management (less memory needed now)
Changed tracking manager: Last sequence ID read from memory now (at startup)
Implemented Webserver for displaying Position, Log and Images packets
Implemented SSDV Decoding Server
- Fixed error in SOI-not-found flag in debug.c
- Added camera-command command (for testing different camera options while watching the livestream)
- Fixed table header in readLog USB command
- Added last-image-id to track-point struct (which is also logged), SSDV transmission will start with next ID on STM32 reset.
This has been done while habhub alway mixes up different images with the same image id.
- Added thread (module) configuration printout on USB debug
- Added GPS_LOG and GPS_OFF flag
- Changed tracking manager initialization strategy:
Tracking Manager runs all time and also logs when there is no new GPS fix
Tracking Manager logs images ID
Tracking Manager doesnt switch on GPS unless there is a position thread running (in order to save energy when position is not sent out)
Implemented several flags in decoder2.py
Added script command.c which sends camera registers via USB to the OV5640.
Changed timer implementation for 2FSK
Implemented concurrent transmission and packet encoding (not working yet)
Wrote documentation for config.c
Implemented grouped transmission (without preamble)
Sven Steudte