Hamlib/racal/ra6790.c

143 wiersze
3.5 KiB
C

/*
* Hamlib Racal backend - RA6790 description
* Copyright (c) 2004 by Stephane Fillod
*
*
* This library is free software; you can redistribute it and/or
* modify it under the terms of the GNU Lesser General Public
* License as published by the Free Software Foundation; either
* version 2.1 of the License, or (at your option) any later version.
*
* This library is distributed in the hope that it will be useful,
* but WITHOUT ANY WARRANTY; without even the implied warranty of
* MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the GNU
* Lesser General Public License for more details.
*
* You should have received a copy of the GNU Lesser General Public
* License along with this library; if not, write to the Free Software
* Foundation, Inc., 51 Franklin Street, Fifth Floor, Boston, MA 02110-1301 USA
*
*/
#ifdef HAVE_CONFIG_H
#include "config.h"
#endif
#include <stdlib.h>
#include <hamlib/rig.h>
#include "idx_builtin.h"
#include "racal.h"
/* FIXME: ISB */
#define RA6790_MODES (RIG_MODE_AM|RIG_MODE_CW|RIG_MODE_SSB|RIG_MODE_AMS|RIG_MODE_FM)
#define RA6790_FUNC (RIG_FUNC_NONE)
#define RA6790_LEVEL_ALL (RIG_LEVEL_RF|RIG_LEVEL_AGC|RIG_LEVEL_IF)
#define RA6790_PARM_ALL (RIG_PARM_NONE)
#define RA6790_VFO (RIG_VFO_A)
/*
* ra6790 rig capabilities.
*
* Required A6A1 serial asynchronous interface
*
*/
const struct rig_caps ra6790_caps = {
.rig_model = RIG_MODEL_RA6790,
.model_name = "RA6790/GM",
.mfg_name = "Racal",
.version = "0.1",
.copyright = "LGPL",
.status = RIG_STATUS_UNTESTED,
.rig_type = RIG_TYPE_RECEIVER,
.ptt_type = RIG_PTT_NONE,
.dcd_type = RIG_DCD_NONE,
.port_type = RIG_PORT_SERIAL,
.serial_rate_min = 300,
.serial_rate_max = 9600,
.serial_data_bits = 7,
.serial_stop_bits = 2,
.serial_parity = RIG_PARITY_EVEN,
.serial_handshake = RIG_HANDSHAKE_NONE,
.write_delay = 0,
.post_write_delay = 10,
.timeout = 2000,
.retry = 3,
.has_get_func = RA6790_FUNC,
.has_set_func = RA6790_FUNC,
.has_get_level = RA6790_LEVEL_ALL,
.has_set_level = RIG_LEVEL_SET(RA6790_LEVEL_ALL),
.has_get_parm = RA6790_PARM_ALL,
.has_set_parm = RIG_PARM_SET(RA6790_PARM_ALL),
.vfo_ops = RIG_OP_NONE,
.preamp = { RIG_DBLST_END },
.attenuator = { RIG_DBLST_END },
.max_rit = Hz(0),
.max_xit = Hz(0),
.max_ifshift = kHz(8),
.targetable_vfo = 0,
.transceive = RIG_TRN_OFF,
.bank_qty = 0,
.chan_desc_sz = 0,
.chan_list = { RIG_CHAN_END, },
.rx_range_list1 = {
{kHz(500),MHz(30)-1,RA6790_MODES,-1,-1,RA6790_VFO},
RIG_FRNG_END,
},
.tx_range_list1 = { RIG_FRNG_END, },
.rx_range_list2 = {
{kHz(500),MHz(30)-1,RA6790_MODES,-1,-1,RA6790_VFO},
RIG_FRNG_END,
},
.tx_range_list2 = { RIG_FRNG_END, },
.tuning_steps = {
{RA6790_MODES,1},
RIG_TS_END,
},
/* mode/filter list, remember: order matters! */
.filters = {
/* at -3dB */
{RIG_MODE_SSB, kHz(2.55)}, /* BW2 */
{RA6790_MODES, Hz(300)}, /* BW1 */
{RA6790_MODES, kHz(1)}, /* BW2 */
{RA6790_MODES, kHz(3.2)}, /* BW3 */
{RA6790_MODES, kHz(6)}, /* BW4 */
{RA6790_MODES, kHz(20)}, /* BW5 */
{RA6790_MODES, 0}, /* accept any BW */
RIG_FLT_END,
},
.cfgparams = racal_cfg_params,
.rig_init = racal_init,
.rig_cleanup = racal_cleanup,
.rig_open = racal_open,
.rig_close = racal_close,
.set_conf = racal_set_conf,
.get_conf = racal_get_conf,
.set_freq = racal_set_freq,
.get_freq = racal_get_freq,
.set_mode = racal_set_mode,
.get_mode = racal_get_mode,
.set_level = racal_set_level,
.get_level = racal_get_level,
.reset = racal_reset,
.get_info = racal_get_info,
};
/*
* Function definitions below
*/